Home/Knowledge

Knowledge

What we will say before a drawing exists.

Short notes for sourcing and engineering conversations. They are not testimonials or a guarantee of glove, water or lifetime performance. A separate OEM engineering white paper (PDF) is linked below.

OEM engineering

OEM Engineering White Paper & Design Guide V2.1

Engineering white paper / design guide · PDF. DOC NO. DM-WP-OEM-2026-V2.1. Scope notice is inside the document.

Download white paper (PDF)

Engineering reply

The reply has three parts.

FIXED

What you already decided

Size, window, host, material, or a reference sample you want to stay close to.

OPEN

What can wait

Print, tail length, controller, bonding and cables stay open until they affect one another.

CHECK

What the sample must show

The questions the first piece has to answer, written down before anyone treats a photo as a part number.

We state a 4-hour engineering reply target. Treat it as a target. If a form submission is your first message to the inbox, the recipient may still need to activate the form service.

Open full engineering-reply note

Catalog status

Reference drawing, or pending photograph.

Reference

8.0 and 10.5 inch

These two PCAP records carry measured cover, sensor and thickness figures from reference drawings. Custom print, holes and bonding are still reviewed with the display. Sample IC on the photo is not a full-series promise.

Read the figures

Pending

Other photographed sizes

Other diagonals keep the title and, where we have it, the photograph. Copied placeholder outlines are omitted on purpose. Fields stay Confirmed per project — no invented millimetre table.

See what is withheld

Concept / Illustrative

Discussion sizes & peer LCM stills

Large-size PCAP, glass cover ideas, and LCM peer stills are labeled Concept or Illustrative. They are not named MPNs and not CGI substitutes for production photos.

Browse the gallery

Open full drawing-status note

Glove and wet touch

Two different requirements.

Tell us the glove material and thickness, the moisture, and the behavior you expect. Sensor, cover and controller are reviewed together. Sample checks are agreed for that stack.

ON THE GLASS

Water while touching

Tuning and cover thickness change the result. It is not assumed from a standard product line.

AT THE SEAL

Ingress protection

Keeping water out of the equipment is a mechanical requirement. It is not the same test as wet-finger tuning.

NOT A PROMISE

No blanket rating

We do not publish an IP rating, a glove thickness limit, or a pass rate.

Open full glove / wet-touch note

Portable / tablet

Selecting a touch display for portable equipment.

Cover OD, VA, FPC exit, connector family, and controller firmware usually matter more than a glossy diagonal label. Full engineering note on its own page.

Portable / tablet note Request a portable brief

FAQ seeds

Short answers before the RFQ freezes.

We only have a tablet teardown photo — can you start?

Yes. Use Reference sample / Customize options from the reference. We still need OD / VA or a caliper photo of the housing opening, plus the host touch and display interfaces. Finished production drawings are not required to begin the engineering reply.

Is 10.5″ “out of focus” if the core band is ≤10.1″?

Day-to-day concentration is ≈5″–10.1″. Photographed larger sizes stay labeled as reference or pending — not a silent SKU expansion. The 10.5″ page is a published reference drawing with sample-IC honesty, not a claim that every project should move above 10.1″.

Where is the price list?

Inquiry only. There is no cart and no public price on this site. Quantity, development cost, and schedule are agreed per project.